Initial Setting Mode [1] - Konica Minolta 3240 User Manual

Key Operator Mode

Initial Setting Mode [1]

Initial settings are the settings that display automatically when the copier is powered on, when
Auto Reset timer is operated, or when [AUTO RESET] key is pressed. These settings can be
changed by the key operator, as shown in this section.
Initially, i.e., at installation, the Basic screen displays the following condition to meet Energy Star
requirements:
Initial Settings for Konica 3240
Copy Mode:
Copy Density: AES
Lens Mode:
Paper Tray:
Sorter:
When Initial settings are changed by the key operator, the new initial settings display when the
copier is powered on, when Auto Reset timer is reached, or when the [AUTO RESET] key is
pressed.
The following initial settings can be changed by the key operator:
Copy mode: [RADF; 1-1; 1-2; 2-2; 2-1]
Copy density: [AES; manual]
Lens mode: [AMS; ratio 50%~200%]
Paper tray: [APS; trays 1, 2, 3, 4, 5, or SPECIAL]
Output mode: [non-sort; sort; staple sort; group]
Setting procedures are described on the following pages.
NOTE: The most commonly-used settings are established at installation. Before changing any of the copier settings, be sure
that you understand the overall and long-range effect of the change.
1-1
1:1
APS
OFF
Initial Settings for Konica 3340
Copy Mode: 1-2
Copy Density: AES
Lens Mode: 1:1
Paper Tray: APS
Sorter: OFF
Key Operator Mode 9-5