Table of Contents
Advertisement
Océ | Printer Maintenance
Cleaning the Pre-fire Stripe Catcher
Items Required:
•
Butyl Gloves (30101017603010101760)
•
Safety glasses
•
Poly-Wipe lint-free Cloth (0505-0283)
•
CGS-80 Solvent (3000-0057)
•
Syringe (3010100747)
Safety Information
Use appropriate safety equipment — butyl gloves, eye protectors, and respirator.
Procedure:
Use the Operator / Maintenance / Access Carriage command to automatically move the
carriage to the blotting station.
Open the gantry doors (capping station side) to access the pre-fire stripe catcher.
Important: Use protective butyl gloves in case of contact with ink or solvent.
3.
Fill the syringe with solvent.
4.
Use the syringe to saturate the top surface of the perforated plate with solvent at
the end of each printing day. Wait 2 minutes to allow the solvent to dilute the ink
and make cleaning of the perforated plate easier.
5.
Using a poly wipe cloth, wipe the surface of the perforated plate clean.
If excessive ink build up occurs, remove the perforated plate using a
Note:
screwdriver and soak it in a container filled with CGS 80 solvent. After
cleaning replace it carefully, ensuring that the top of the perforated plate is
flush with the top of the catcher.
7-80
3010100686-B
Advertisement
Table of Contents
Troubleshooting
