3.
Mount a new roll of blotting cloth (part #301200247) on the lower supports. Run the
cloth up the back and over the top of the blotting station.
4.
Mount the old cardboard core on the upper supports ensuring that the pins on the
spindle engage properly with the notched core.
5.
Remove the strip of backing tape from the start of the new roll and stick the new roll
to the old core.
Note:
Make sure that you align the cloth and not the plastic start of the roll to the old core.
6.
Advance the new cloth by hand ensuring that there is no paper tape or loose fibers
adhering to the cloth from where the paper tape was stuck to the roll.
10/16/03
Figure 26 Mounting the Old Cardboard Core
Figure 27 Changing Blotting Paper
The Blotting Station |
4-61