Oce Arizona T220 User Manual page 17

What to do with Ink Spills on Surfaces
Observe precautions as noted above, then:
What to do with Ink Spills on Persons
• Eye contact: immediately flush eyes with large amounts of water. Get
immediate medical attention.
• Skin contact: flush skin with large amounts of water. If irritation persists,
get medical attention.
• Inhalation: remove person to fresh air. If not breathing, get immediate
medical attention and give artificial respiration. If breathing is difficult, get
immediate medical attention.
• If swallowed: call a physician immediately. Only induce vomiting at the
instructions of a physician. Never give anything by mouth to an
unconscious person.
IR Heater
Two infared heaters mounted on the gantry are used to dry the ink during printing. Each
heater has two 3kw elements. The printer uses 3 of the 4 possible elements thus
providing a maximum of 9kw of heat. The carriage passes under the heater and has a
protective cover that reflects heat. The heater operates automatically and does not
require operator intervention.
Caution:
Keep hands clear of the heater assembly. This area will be hot during
and right after printing.
10/16/03
a) Ventilate the area;
b) Contain the spill;
c) Cover with absorbent material;
d) Collect spilled absorbent material;
e) Place in a closed container;
f) Clean up residue with water (do not release to waterways or sewer);
g) Incinerate in a permitted hazardous waste incinerator.
Safety Information |
1-5