T220 Printing Direction And Offsets - Oce Arizona T220 User Manual

Changing Horizontal and Vertical Offsets
This display allows you to change first the horizontal and then the vertical offsets.
Print Mode
speed 1x
Use the ACCEPT key to move through the displayed digits. The selected digit has an
underline indicating it can be increased or decreased using the + or - keys. When the digit
you want to use is displayed, press ACCEPT and the underline moves to the next digit.
When you are at the last digit, pressing ACCEPT advances to the Place Media display.
Place Media Menu
The menu now displays the following pre-print message:
Print Mode
Place media on table.
speed 1x
Press ACCEPT and the gantry will move to position itself over the media. Printing does
not start immediately as there are some warmup procedures to follow first, including
applying heat from the lamps to warm up the media.
When printing begins, the image start point is the lower left corner of the image.
10/16/03
Enter new H offset:
H: +04.00mm,
Press ACCEPT to start printing
Figure 13 T220 Printing Direction and Offsets
(-6 to 2783mm)
V: +0755mm
Turn vacuum ON.
Printing a Job |
3-37