Changing Print Job Settings - Oce Arizona T220 User Manual

Océ | Operating the Arizona T220

Changing Print Job Settings

3.3.2
The following three settings may be altered if the operator chooses to change them when
the print information for a particular job is displayed:
• Media Thickness
• Heat Setting
• Horizontal and Vertical Offsets
Media Thickness
The desired media thickness is first selected using PosterShop and then verified at the
control panel prior to printing. The Pre-Fire Stripe Catcher Adjustment ensures that the
print heads are set to the desired height. As a precaution against damaging the
printheads, there is a media touch rotary switch located on the lead edge of the carriage
used to detect any obstacles higher than the media on the table. If anything on the table
is sitting too high, including the media, the media touch rotary switch will cause the
gantry to stop and the control panel will alert the operator of the problem.
ODGS recommends that the operator measure the media thickness with a set of
calipers.This ensures optimum conditions for achieving the best possible print quality by
placing the print nozzles at the optimal height above the media. Since the clearance
between the media and the print heads is only 2mm (0.08 in.), altering the clearance has
a negative impact on the bi-directional alignment.
Caution:
media supply box. When media thickness changes, the Pre-Fire Strip
catcher must be manually adjusted to the correct height.
If you pressed + or - to change setings while the print job information was displayed, the
following screen appears.
Print Mode
speed 1x
Use the ACCEPT key to move through the displayed digits. The selected digit has an
underline indicating it can be increased or decreased using the + or - keys. When the digit
you want is displayed, press ACCEPT and the underline moves to the next digit. When
you are at the last digit, pressing ACCEPT advances to the Pre-Fire Stripe Catcher
Adjustment to verify media thickness.
Print Mode
speed 1x
3-34
Do not rely on media thickness specifications listed on the
Enter new media thickness:
04.00mm
Pre-Fire Stripe Catcher Adjustment
Step 1: 'ACCEPT" to move the carriage
3010100686-B