Sharp Edge Of The Strip Butts Up Against The Media - Oce Arizona T220 User Manual

4. Push the strips up against the long edges of the media, with the sharp edge protruding
into the middle part of the media edge. The strips will be held in place by the vacuum
holes underneath them
Figure 28 shows a sheet of 4'x8' Fome Cor on the printer table with a media holder strip
placed on one side of the media.
In Figure 29 note that the sharp edge of the media holder strip butts up against the middle
of the edge of the media. This prevents warping and increases the effect of the vacuum.
• The strips can be printed on if a bleed is required in the image. If the strips
are used for a bleed and the media thickness is more than 2mm greater than
the strips, overspray and nozzle dropout is likely to occur.
• To clean the strips follow the same procedure as for cleaning the table,
using either CGS80 or laquer thinner — See "Removing Ink From the
Table" on page 79.
• When not in use, the strips should be stored flat.
10/16/03
Figure 29 Sharp edge of the strip butts up against the media.
Handling Media |
5-65