Setting Media Thickness - Oce Arizona T220 User Manual

Press ACCEPT to move the carriage away from the capping station and thus allow
access to the Pre-Fire Stripe Catcher.
Print Mode
speed 1x
This turns off the interlock on the gantry doors and allows you to open them. Insert a
shim of equivalent media thickness or a piece of media itself into the slot on the catcher
assembly. This will set the appropriate height for the media.
After placing the shim in the catcher adjustment slot, close the gantry doors and press
ACCEPT to advance to the next step.
Print Mode
speed 1x
Press ACCEPT again to bring the carriage back to the capping station. The carriage will
then check the height and move to the Heater Setting option if the height is OK. If the
shim is too thick in relation to the current thickness setting, the control panel displays an
error message and then prompts you to re-adjust the catcher.
If the shim is too thin, there is no error message displayed. However this may
Note:
result in a thin mist of ink that could accumulate on the nozzle plate and
affect performance.
10/16/03
Pre-Fire Stripe Catcher Adjustment
Step 2: Open door and adjust catcher
Figure 12 Setting Media Thickness
Pre-Fire Stripe Catcher Adjustment
Step 3: 'ACCEPT" to park the carriage
Printing a Job |
3-35