Park Carriage - Oce Arizona T220 User Manual

PUMP SOLVENT
This turns on the solvent pump for the duration set in this menu — 1 - 30 seconds
(default is 10 seconds). Solvent is pumped up to the capping tray and into the foam
pads for the specified amount of time.
FILL RESERVOIR
This command manually fills one or more ink reservoir with ink. This is generally
only used if ink-fill is turned Off and the user wants to manually ensure that the
ink reservoirs are full of ink. The system stops the filling when the ink reservoir
level sensor indicates that the ink reservoir is full.
ACCESS CARRIAGE
This command raises the carriage to the currently-set media height and moves the
carriage over to the blotting station. This is useful to gain access to the underside
of the carriage in order to manually clean the print heads.

PARK CARRIAGE

This command moves the carriage to the capping station and lowers the carriage
onto the foam pads (called 'capping'). It is necessary to perform this step any time
the operator has been doing manual maintenance and wishes to park and cap the
carriage.
RAISE CARRIAGE
This command raises the carriage to currently-set media height then moves the
heads over the drain, which allows the carriage to be moved manually for service
access.
Note:
10/16/03
The carriage will not self-cap when it is raised. Therefore, the heads
will dry out if left in this position for too long (i.e., more than 5
minutes).
Menu Structure |
2-15