Print Job Parameter Options - Oce Arizona T220 User Manual

Océ | Operating the Arizona T220
You can either:
Tip: Use the MENU key to move to the next option if no changes are required for a
particular field.
Press ACCEPT and the next step in printing is determined by whether the Print
Parameters were enabled in the Operator/Print Parameters menu. If this is set to OFF in
the Operator/Print Parameters/Statistics menu, the control panel display shows the
message "Place media on the table" and the print job can begin. However, if it is set to
ON, then either some, or all of the following set of print job options are displayed,
allowing you to change them.
Which of the Print Parameters Options are displayed, and thus able to be
Note:
changed, is determined by whether or not that particular job option was
enabled in the Operator\Enable Job Parameters Change menu.

Print Job Parameter Options

3.3.1
The print job parameter options consist of five functions that support printing. If a
particular option was enabled in the Operator\Enable Job Parameters Change menu, its
associated screen is displayed in the following order.
Printing Direction
Print Mode
speed 1x
Press + or - to change the printing direction. Options are Single or Bidirectional —
single means that the nozzles will print only in the right to left direction, while
bidirectional prints in both directions. Press ACCEPT when the printing option you
want is displayed.
Home Drying Delay
Sets a delay time for the carriage each time it reaches the home position during printing.
Use the ACCEPT key to move through the displayed digits. The selected digit has an
3-32
a) Press + or - if you want to change media thickness, heater duty cycle,
image offsets, or print job parameters (if Parameters is enabled); or
b) Press ACCEPT to continue the print job.
PRINT PARAMETERS
Dir:
PRINT PARAMETERS
Drying delay-home: 0.0 sec
bidir L<-->R
3010100686-B