Table of Contents
Advertisement
Use the +/- buttons to select the number of passes (1 -100), and press ACCEPT.
10. Press ACCEPT. You then see:
The printer begins printing the Nozzle Print. The control panel displays the on-
line statistics.
10/16/03
6. Press ACCEPT. You then see:
NOZZLE PRINT
dir: bidir L<-->R
7. Press ACCEPT. You then see:
NOZZLE PRINT
1 pass
8. Press ACCEPT. You then see:
NOZZLE PRINT
vertical offset from origin: x.xx m
Use the +/- buttons if you want to change the origin
9. Press ACCEPT. You then see:
NOZZLE PRINT
print width:
NOZZLE PRINT
Thickness: 0.00m (noUL),
Use the +/- buttons if you want to change the thickness or heat setting.
Refer to section "Changing Print Job Settings" on page 34 for details
on changing these settings.
Heat xx%
Menu Structure |
2-17
Advertisement
Table of Contents
Troubleshooting
