Oce Arizona T220 User Manual page 39

This option allows you to specify a time period in seconds (1-600) to wait before
initiating printing. This delay may be required if the software sending the print job
does not use a PRINT command. If the printer seems to hang during a transfer,
adjust this value. The recommended setting for the T220 is 60 seconds.
If your software uses a PRINT command, the timeout value is ignored. Use the
+/- keys to adjust to the desired timeout period, press ACCEPT to enter value and
navigate to the next menu.
This parameter pertains to the SCSI card being used on the host PC. In the case of
the T220 using the Adaptec 2190 card, this parameter should be set to On so that
the host PC and the printer can negotiate the speed.
10. Press ACCEPT to complete your inspection of the SCSI settings. You
11. Press ONLINE to exit the menu system.
10/16/03
3. Otherwise you will see:
CONFIGURE I/O
active: SCSI
4. Press the ACCEPT button to select the SCSI port option, and you then
see:
SCSI PORT
SCSI address: 5
5. Press ACCEPT to accept the T220 default address.
6. The timeout option then displays:
SCSI Port
timeout 60 seconds
7. You then see:
SCSI PORT
wide SCSI: off
8. You then see:
SCSI PORT
ultra SCSI: on
9. Press ACCEPT to view the final SCSI option.You then see:
SCSI PORT
Interface cable detected: LVD
then see:
CONFIGURE I/O
active: SCSI
Menu Structure |
2-27