Replaceable Parts
Assembly Replacement Sequence
Assembly Replacement Sequence
The following steps show the sequence that you should follow to replace an assembly in the network
analyzer.
Step 1. Identify the faulty group. Begin with
troubleshooting chapter that identifies the faulty assembly.
Step 2. Order a replacement assembly. Refer to this chapter.
Step 3. Replace the faulty assembly and determine what adjustments are necessary. Refer to
"Repair and Replacement Procedures."
Step 4. Perform the necessary adjustments. Refer to
Step 5. Perform the necessary performance tests. Refer to
6-4
PNA Series Microwave Network Analyzers
Chapter 4, "Troubleshooting."
Chapter 3, "Tests and Adjustments."
Chapter 3, "Tests and Adjustments."
E8362C, E8363C, E8364C
Follow up with the appropriate
Chapter 7,
Service Guide E8364-90038