Agilent Technologies E8362C Service Manual page 334

Repair and Replacement Procedures
Removing and Replacing the Midweb and the B1 Fan
Removing the Fan
Refer to Figure 7-35.
1. To remove the fan, it is necessary to remove the four nylon rivets that attach it to the midweb. To do this,
use the Pozidriv screwdriver on the nylon screw (item
rivet. Turn and push the rivet out of the rivet hole. Once the four rivets are out, remove the fan.
Figure 7-35 B1 Fan Removal
Replacement Procedure
1. Reverse the order of the removal procedure.
2. Perform the post-repair adjustments, verifications, and performance tests that pertain to this removal
procedure. Refer to Table 7-2 on page
7-78
➀
) and a small blade screwdriver to stabilize the
7-82.
PNA Series Microwave Network Analyzers
E8362C, E8363C, E8364C
Service Guide E8364-90038