Post-Repair Procedures - Agilent Technologies E8362C Service Manual

Repair and Replacement Procedures

Post-Repair Procedures

Post-Repair Procedures
After the replacement of an assembly, you must perform the service procedures in the order listed in
7-2.
Procedures referenced in this table are located in
otherwise.
Table 7-2 Related Service Procedures
Replaced Assembly
A1 keypad assembly
A2 display assembly
A3 front panel interface board No adjustment needed
A4 power supply assembly
A6 SPAM board
A8 fractional-N synthesizer
board
A9 fractional-N synthesizer
board
A10 frequency reference
board
A11 phase lock board
A12 source 20
A13 frequency offset receiver
assembly
A14 system motherboard
A15 CPU board
A16 test set motherboard
7-82
Chapter 3, "Tests and Adjustments,"
Adjustments
and Other Procedures
No adjustment needed
No adjustment needed
No adjustment needed
No adjustment needed
LO Power Adjustment
Offset LO Adjustment
10 MHz Frequency Reference
Adjustment
Restore option data (Refer to
"Repairing and Recovering
Option Data" in Chapter 8.)
No adjustment needed
3.8 GHz PMYO Frequency
Adjustment
Source Calibration Adjustment
Offset LO Adjustment
No adjustment needed
No adjustment needed
Reinstall the serial number.
(Refer to "Installing or Changing
a Serial Number" in Chapter
Re-enable all hardware options.
(Refer to "Enabling or Removing
Options" in Chapter 8.)
PNA Series Microwave Network Analyzers
Verification, Performance,
and Other Tests and Procedures
Front Panel Keypad and RPG Test
A2 Display Test in Chapter 4
Front Panel Keypad and RPG Test
Test in Chapter 4
None needed
Noise Floor Test
Trace Noise Test
System Crosstalk Test
Frequency Accuracy Test
The Operator's Check
The Operator's Check
Frequency Accuracy Test
Frequency Accuracy Test
Source Power Accuracy Test
Source Power Linearity Test
Frequency Accuracy Test
The Operator's Check
Front Panel Keypad and RPG Test
Test in Chapter 4
The Operator's Check
The Operator's Check
The Operator's Check
8.)
System Crosstalk Test
E8362C, E8363C, E8364C
Table
unless specified
in Chapter 4
and A2 Display
and A2 Display
Service Guide E8364-90038