Enabling Or Removing Options - Agilent Technologies E8362C Service Manual

General Purpose Maintenance Procedures
Option Enable Utility

Enabling or Removing Options

There are two types of options:
• Hardware: Hardware options involve adding additional hardware to the analyzer. After the proper
hardware has been installed in the analyzer, the option can be enabled using the option
enable utility.
It is necessary to re-enable all hardware options if the test set motherboard is replaced.
• Software: Software options add features or functionality to the analyzer without the need for
additional hardware. These options are enabled using a special keyword. They are
enabled using the option enable utility.
It is necessary to backup all installed software options if the frequency reference board is
replaced.
NOTE Some applications require a license key that is provided by Agilent. If you do not have the
required license key, contact Agilent for assistance. Refer to
page 2-12.
To enable or remove an option:
1. Start the option enable utility. Refer to
2. Click the arrow in the
appear.
010 - Time Domain
UNL - Bias Tees w/Atten
014 - Configurable Test Set
016 - Receiver Attenuators
080 - Frequency Offset Mode
081 - Reference Transfer Switch
083 - Mixer Measurement Appl
??? - Enter Unlisted Option
3. Click on the option that you wish to either enable or remove, and then click
is appropriate.
4. If the desired option is not available in the list, select
allow you to enter the option number. Enter the option number and follow the instructions on the display.
8-16
"Accessing the Option Enable Utility" on page
box. A list of available options, similar to the list below, will
Select Desired Option
PNA Series Microwave Network Analyzers
"Contacting Agilent" on
Enable
. A dialog box appears that will
Enter Unlisted Option
E8362C, E8363C, E8364C
8-15.
or , whichever
Remove
Service Guide E8364-90038