Agilent Technologies E8362C Service Manual page 269

PNA Series Microwave Network Analyzers
E8362C, E8363C, E8364C
Replacing the A2 Display Assembly
1. Remove the inverter board. Refer to the procedure on
⑧
cable clamp (item
1. Remove the touch screen controller board. Refer to above procedure.
2. Remove the six retaining screws (item
3. Remove the A2 display assembly from the front panel assembly.
4. Install the new A2 display assembly by reversing the removal instructions.
5. Perform the post-repair adjustments, verifications, and performance tests that pertain to this
replacement procedure. Refer to
Figure 7-4 Front Panel Subassemblies Removal
Service Guide E8364-90038
).
⑨
) from the A2 display assembly.
Table 7-2 on page
Repair and Replacement Procedures
Removing and Replacing Front Panel Subassemblies
page 7-12. Remove the inverter cable from the
7-82.
7-13