Agilent Technologies E8362C Service Manual page 30

General Product Information
Required Service Test Equipment
a
Equipment
Extender board
T-8 TORX driver
T-10 TORX driver
T-20 TORX driver
1/4-inch and 5/16-inch
open-end wrench
5/16-inch, open-end torque
wrench
1-inch, open-end torque
wrench
20-mm, open-end torque
wrench
Adjustable antistatic wrist
strap
Antistatic wrist strap
grounding cord (5 foot)
Static control table mat and
earth ground wire
USB flash ROM drive
a. Unless specified otherwise, equipment listed is required for all analyzer models.
b. P = Performance tests, A = Adjustments, T = Troubleshooting, R = Repair, V = System verification
2-10
Critical Specifications
Tools
N/A
0.6 N-m (5 in-lb) setting
0.5, 0.8, and 1.0 N-m
(4, 7, and 9 in-lb) settings
2.4 N-m (21 in-lb) setting
Thin profile
1.1 and 2.4 N-m
(10 and 21 in-lb) settings (for
semi-rigid cables)
8.1 N-m (72 in-lb) setting (for
Port 1 and Port 2 connector
nuts)
0.9 N-m (8 in-lb) setting (for Port
1 and Port 2 measurement
connections)
Static Safety Parts
N/A
N/A
N/A
Miscellaneous
N/A
PNA Series Microwave Network Analyzers
E8362C, E8363C, E8364C
Recommended
Alternate
Model or Part
Model Number
Number
E8356-60021 None
N/A N/A
N/A N/A
N/A N/A
8710-0510 N/A
N/A N/A
N/A N/A
N/A N/A
9300-1367 None
9300-0980 None
9300-0797 None
Any None
Service Guide E8364-90038
b
Use
T
R
T,R
T,R
A,R
T,R
R
R
P,A,T
P,A,T
P,A,T
P,A,R