Raising And Removing The Receiver Deck - Agilent Technologies E8362C Service Manual

Repair and Replacement Procedures

Raising and Removing the Receiver Deck

Raising and Removing the Receiver Deck
Tools Required
• T-10 TORX driver (set to 9 in-lb)
Raising the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Disconnect the power cord.
2. Remove the outer cover.
3. Place the analyzer bottom-side up on a flat surface.
4. With a T-10 TORX driver, remove the four screws (item
5. Pull the latch pin (item
6. Lift the receiver deck to partially raise it, then release the latch pin (item
fully raised position and ensure that the latch pin latches in the raised position.
Lowering the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Pull the latch pin (item
2. Lift the receiver deck to partially lower it, then release the latch pin (item
its fully lowered position and ensure that the latch pin latches in the lowered position.
3. With a T-10 TORX driver, install the four screws (item
Removing the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Raise the receiver deck as outlined in
2. Disconnect the flexible cables (item
connectors for proper reconnection later.
3. Pull the latch pin (item
4. Lift the side of the receiver deck that was just released, above the side of the analyzer, and then lift the
entire receiver deck out of the analyzer.
Replacing the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Reverse the procedure for
7-8
➁
) toward the center of the analyzer to release receiver deck.
➁
) toward the center of the analyzer to release the receiver deck.
"Raising the Receiver Deck,"
③
) and the two ribbon cables (item
⑤
) to release one side of the receiver deck.
"Removing the Receiver Deck,"
PNA Series Microwave Network Analyzers
①
), securing the receiver deck.
➁
). Lift the receiver deck to its
➁
). Lower the receiver deck to
①
), to secure the receiver deck.
above.
④
). Label the cables and
above.
E8362C, E8363C, E8364C
Service Guide E8364-90038