Step 4: Connect Your M11 To The Network; Step 5: Check That The Connection Works; Default Settings - Nokia M11 T66220 User Manual

Nokia M11 User's Manual
M11> restart
REBOOT scheduled in 2 seconds
Goodbye.
The following changes were made in the above basic router example:
D
Ether-llc encapsulation was selected for ATM channel 1. This
encapsulation is used by your company's main office bridge.
Alternatively, ether-vcmux encapsulation could be used. See
Chapter 6 for more information on the payload encapsulations.
D
IP functionality, default gateway and interwan routing were
disabled in the Ethernet. Note, that you have to go through the IP
option twice: first to disable Ethernet and gateway options and
then to disable the IP option.
D
DHCP option was disabled.
D
Bridge was enabled.
Warnings related to 0.0.0.0 settings of DNS servers are irrelevant in
this configuration because the M11 is now a transparent bridge.
Messages given as Warnings are not fatal. If an actual error message
occurs the configuration has not been validated successfully and M11
does not save the configuration.

Step 4: Connect your M11 to the network

Connect the ADSL cable between the telephone socket and the LINE
connector of the M11. Then connect the ETH connector of the M11 to
your office hub with a direct cable. The green LAN LNK indicator
lights up when you connect the Ethernet cable. After a while the DSL
indicator starts blinking, indicating that the connection is being
established. The green DSL light indicates that the unit has a
connection to the central office.

Step 5: Check that the connection works

Establish a connection to the office server to check that the connection
works.
4.4

Default settings

The table 4-1 indicates the default settings for Nokia M11. By default,
Nokia M11 works as a plug and play unit in the Internet access
application. In the table, the terms "Node" and "Subnode" refer to
Config command hierarchy nodes (see Chapter 5).
4-22
E Copyright Nokia Networks Oy
C33833001SE_00