Table of Contents
Advertisement
Command
Description
Syntax
Arguments
Example
Note
You must enable IP routing before you can enter other IP routing
settings for the serial port. If you turn off IP routing and save the new
configuration, the Nokia M11 clears IP routing settings.
Command
Description
Syntax
Arguments
Example
C33833001SE_00
Enable/disable routing IP over PPP link
Enables/disables IP routing through the specified logi-
cal ATM channel using ppp-vcmux encapsulation.
set ip ip-ppp {vccx} option [on|off]
The first argument identifies the ATM channel (vccx,
x = 1 ... 8). If there is only one ATM channel using ppp-
vcmux, encapsulation you can leave the argument
vccx out. The on/off argument enables/disables rout-
ing.
M11> set ip ip-ppp vcc1 option off
Set IP address to ATM channel using PPP-vcmux
encapsulation
Assigns an IP address to the specified logical ATM
channel using ppp-vcmux encapsulation.
set ip ip-ppp {vccx} address [ip_address]
The first argument identifies the ATM channel (vccx,
x = 1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation, you can leave the argument
vccx out. If you specify an IP address other than
0.0.0.0, your Nokia M11 will not negotiate its IP address
with the remote peer. If the remote peer does not ac-
cept the IP address specified in the ip_address argu-
ment as valid, the link will not come up. The default
value for the ip_address argument is 0.0.0.0, which
indicates that the WAN port will use the IP address as-
signed to it by the remote peer. Note that the remote
peer must be configured to supply an IP address to
your Nokia M11 if you enter 0.0.0.0 for the ip_ad-
dress argument.
M11> set ip ip-ppp vcc2 address 0.0.0.0
E Copyright Nokia Networks Oy
Management
5-57
Advertisement
Table of Contents
