Bncp Setting - Nokia M11 T66220 User Manual

Command
Description
Syntax
Arguments
Example

BNCP setting

Command
Description
Syntax
Arguments
Example
C33833001SE_00
Set static ARP table entry
Sets a static IP address – MAC address mapping to the
ARP table. This command can be used if you have de-
vices on the Ethernet which do not understand ARP re-
quests. You must have admin rights to configure static
ARP table entries.
set ip static-arp ip-address [ip-address] hardware-ad-
dress [hardware-address]
The ip-address argument defines the IP address as-
signed to the device. The hardware-address argu-
ment is the hardware MAC address of the device.
m11> set ip static-arp ip-address
192.168.1.2 hardware-address
00.40.43.02.20.1f
Enable/disable BNCP
Specifies whether the Bridge Network Control Protocol
(BNCP) option can be used on ATM channels using
ppp-vcmux encapsulation. See set ip wan com-
mands above.
set bncp option [on|off]
The argument enables/disables BNCP option.
M11> set bncp option on
E Copyright Nokia Networks Oy
Management
5-73