Table of Contents
Advertisement
Chapter 5
Management
M11 can be managed with a Web browser or command line interface
(CLI). The Web configuration pages of M11 can be accessed through
the Ethernet port or through the ADSL/ATM channels of M11. In order
to access the Web management feature, the IP functionality must be
activated and an IP address must be given to the corresponding
interface.
The command line interface (CLI) can be accessed through the console
port on the M11 front panel. The console interface is an asynchronous
V.24/V.28 character-based interface with 9600 bit/s, 8 bits, no parity, 1
stop bit and no flow control. A special cable for connecting PC's serial
port to this interface is available from Nokia, product code E64320.01.
The CLI contains an in-built step procedure which helps you to
configure your M11 through the CLI. This procedure is presented in
section Stepping through M11 configuration in this chapter.
The command line interface can also be accessed through the Ethernet
port of M11 or through the ADSL/ATM channels of M11 on top of the
telnet protocol. In order to use the CLI through telnet, the IP
functionality must be activated and an IP address must be given to the
corresponding interface.
5.1
Browser management
You can use your PC's Web browser software to access the Web
configuration pages in M11. To access the Web pages you must know
the IP address of your M11 or, alternatively, the "name" that your M11
recognises.
C33833001SE_00
E Copyright Nokia Networks Oy
Management
5-1
Advertisement
Table of Contents
