Table of Contents
Advertisement
The Internet access application requires that your PC uses Dynamic
Host Configuration Protocol (DHCP) to get its network address (IP
address) from your Nokia M11.
The installation procedure depends on whether you want to use data
services only or data and simultaneous telephone services. If you want
data services only, start from Step 1a. If you want both data and
telephone services, start from Step 1b .
M11 has an optional three-level password (user, user-admin, and
admin), which also affects the installation procedure. By default, the
password is disabled but it can be enabled through the command line
interface (see Chapter 5 Management). Steps 4b and 5b describe the
actions when password is enabled.
Step 1a: Connect cables (data services only)
Connect the following cables:
D
Connect the mains power cord first to Nokia M11 and then to a
power outlet.
D
Connect the Ethernet cross cable to the Nokia M11 ETH connector
and the other end to your PC's Ethernet port.
D
Connect the ADSL cable to the telephone socket.
D
Go to Step 2.
Step 1b: Connect cables (data and telephone services)
If you want to use your telephone line for both the high-speed ADSL
service and normal telephone service, you must install a POTS filter.
You can use Nokia POTS filter T66130 or T66150. See separate
installation instructions for POTS filters.
Connect the following cables:
D
Connect the mains power cord first to Nokia M11 and then to a
power outlet.
D
Connect the Ethernet cross cable to the Nokia M11 ETH connector
and the other end to your PC's Ethernet port.
D
Connect the ADSL cable and the telephone according to the
separate POTS filter installation instructions.
D
Go to Step 2.
Step 2: Switch on M11
The green STA indicator and red DSL indicator light up. After a while
the DSL light starts blinking, indicating that the connection is being
C33833001SE_00
E Copyright Nokia Networks Oy
Installing M11
4-3
Advertisement
Table of Contents
