Nokia M11 T66220 User Manual page 119

Nokia M11 User's Manual
Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
5-64
Enable/disable RIP receive function on channels
using IP over ATM or bridged encapsulations
Specifies whether M11 should use Routing information
protocol (RIP) broadcasts to update its routing tables
with information received from other routers on the
other side of the specified ATM link using ip-llc, ip-
vcmux, ether-llc, or ether-vcmux encapsulation.
set ip dsl {vccx} rip-receive [off | v1 | v2 | v1-compat]
The first argument identifies the ATM channel (vccx,
x = 1 ... 8). If there is only one ATM channel using one
of these encapsulations, you can leave the argument
vccx out. Both RIP version 1 and RIP version 2 func-
tionalities can be simultaneously activated. v1-compat
argument enables the receiving of both RIPv1 and
RIPv2 packets. RIP cannot be activated if address
mapping is ON.
M11> set ip dsl vcc2 rip-receive off
Flush routes
Enabled flush routes function deletes the learned
routes from the routing table when the PPP connection
is disconnected. Address mapping must be off.
flush-routes [on|off]
The argument enables/disables the flush routes func-
tion.
M11> flush-routes on
E Copyright Nokia Networks Oy
C33833001SE_00