Table of Contents
Advertisement
Note
You must have admin rights to set transmit priorities.
3. Enable/disable IP.
IP Settings allow you to activate the IP layer function of the ATM
channel. Local address and peer address specify the basic IP
address parameters of the ATM channel interface (PPP over
ATM). If you write 0.0.0.0 in these fields, M11 will try to get them
from the network using either IPCP protocol (ATM channel using
PPP) or DHCP (ATM channel not using PPP).
Admin Restrictions is used to apply management restrictions to the
channel. If you select Admin-Disabled, you cannot manage M11
through this channel. If you select Admin-Only, this channel will
be used as a dedicated management channel.
Address mapping radio button activates/deactivates the Network
Address Port Translation (NAPT).
4. Configure Routing Information Protocol (RIP) settings.
Enable/disable dynamic routing for the active IP interface on the
ATM channel by selecting the corresponding radio buttons. If
RIP-send is selected, M11 sends RIP messages (version 1, 2 or
both) to the network. If RIP-receive is selected, M11 listens to RIP
messages from the network. RIP-send with V1-compat option
enables the sending of RIPv2 packets using broadcast.
RIP-receive with V1-compat option accepts both RIPv1 and
RIPv2 packets. If you enable Flush Routes, the learned routes are
deleted when the PPP connection is disconnected.
5. Enable/disable PAP/CHAP authentication and fill in the
corresponding usernames and passwords if authentication is
needed. Ask your service provider which authentication to use.
6. Add static routes to the routing table of the interface.
Enter destination address, net mask and gateway and click Add.
C33833001SE_00
E Copyright Nokia Networks Oy
Management
5-15
Advertisement
Table of Contents
