Bridge Page; Filling In Bridge Settings - Nokia M11 T66220 User Manual

Nokia M11 User's Manual

5.1.4 Bridge page

Bridge page is used to enable/disable bridging. When bridging is
enabled the page is used to select the interfaces that are included in the
bridging function.
Figure 5-7
Only those ATM interfaces that support 'ether-llc' or 'ether-vcmux'
encapsulation or 'ppp-vcmux' encapsulation with BNCP support can
be used in bridging operation.

Filling in bridge settings

1. Turn on bridge
2. Click ATM to configure ATM channels, if needed (see Section
5.1.5).
3. Select the interfaces you want to use for bridging.
Ethernet indicates the Ethernet interface of M11. DSL VCC radio
buttons indicate ATM channels using 'ether-llc' or 'ether-vcmux'
encapsulation. WAN VCC radio buttons indicate ATM channels
using 'ppp-vcmux' encapsulation with BNCP support.
4. Enable/disable bridging between ATM VCCs.
This option can be used when multiple M11s are connected
together using bridged connection. Disabling the bridging
between the VCCs eliminates the loops from the bridged network.
5-12
Bridge page
E Copyright Nokia Networks Oy
C33833001SE_00