Quickconfig Page - Nokia M11 T66220 User Manual

D
"Router" link is used to configure some generic routing/IP address
management parameters and Ethernet interface IP parameters if
M11 is used as a router.
D
"Bridge" link is used to enable bridging and attach interfaces to the
bridge function.
D
"ATM" link is used to activate ATM channels, select payload
encapsulations to ATM and configure important ATM channel
parameters.
D
"Restart" M11 link restarts your M11 causing it to activate any
updated configuration information.
D
"SNMP" link is used to configure the SNMP parameters of M11.

5.1.2 QuickConfig page

The QuickConfig page lets you enter basic configuration information
for your Nokia M11. To display the QuickConfig page, click
QuickConfig on the M11 homepage. The QuickConfig page also
opens when you connect to your M11 for the first time.
Figure 5-2
By clicking the Internet Access-Single PPP button you can enter basic
Nokia M11 settings for an Internet access application. Clicking the
Internet Access-Single PPP opens the QuickStart page. Normally you
only need to enter your username and password for the Internet
service.
If you have configured multiple PPP channels into use, you can
manage them through the PPP Connection Manager.
Note
If a user-admin password has been assigned to your M11, the PAP and
CHAP Setup page will be displayed instead of the QuickConfig page.
C33833001SE_00
QuickConfig page
E Copyright Nokia Networks Oy
Management
5-3