Logging In - Nokia M11 T66220 User Manual

To connect your Nokia M11 to a terminal or terminal emulators:
1. Plug the special cable E64320.01 into the console port behind the
hatch on the Nokia M11 front panel.
2. Connect the other end of the serial cable to the serial port on your
terminal (or terminal emulator) or the serial port of your computer.
3. Turn on the terminal or run the terminal emulator program on your
computer.
Use the following settings to configure your terminal emulation
session:
Setting
Speed
Parity
Data bits
Stop bits
Duplex
Flow control
The console interface uses the same command line interface as the
telnet interface.

Logging in

The command line interface login process emulates the login process
for a Unix host. If your Nokia M11 has been assigned a system
password, you must enter a username (up to 64 characters) and your
administrator, user-administrator or user password.
Entering your username lets Nokia M11 record your access; your
username is not used to validate your authorisation. The passwords
give you the following rights:
D
User password
D
User-administrator change CHAP and PAP settings, configure
D
Administrator
C33833001SE_00
Value
9600
None
8
1
Full
None
view (but not change) M11 settings and
monitor statistics
pinhole, Ethernet and router settings as well
as monitor M11 statistics
change M11 settings and view statistics
E Copyright Nokia Networks Oy
Management
5-23