Table of Contents
Advertisement
Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
C33833001SE_00
Set IP address to channels using IP over ATM or
bridged encapsulations
Assigns an IP address to the specified logical ATM
channel using ip-llc, ip-vcmux, ether-llc, or ether-vcmux
encapsulation.
set ip dsl {vccx} address [ip_address]
The first argument identifies the ATM channel (vccx,
x = 1 ... 8). The second argument is the IP address of
that channel. If there is only one ATM channel using
one of these encapsulations, you can leave the argu-
ment vccx out. If you enter 0.0.0.0 as the IP address,
M11 will retrieve the IP address through the remote
peer using Dynamic Host Configuration Protocol.
M11> set ip dsl vcc2 address 0.0.0.0
Set broadcast address to channels using IP over
ATM or bridged encapsulations
Assigns a broadcast IP address to the specified logical
ATM channel using ip-llc, ip-vcmux, ether-llc, or ether-
vcmux encapsulation.
set ip dsl {vccx} broadcast [broadcast_address]
The first argument identifies the ATM channel. The sec-
ond argument is the broadcast address to be assigned
to that channel. If there is only one ATM channel using
one of these encapsulations, you can leave the argu-
ment vccx out. If you enter 0.0.0.0 as the IP broadcast
address, M11 will retrieve the IP address through the
remote peer using Dynamic Host Configuration Proto-
col.
M11> set ip dsl vcc2 broadcast 0.0.0.0
E Copyright Nokia Networks Oy
Management
5-61
Advertisement
Table of Contents
