Step 4: Connect Your M11 To The Network - Nokia M11 T66220 User Manual

Nokia M11 User's Manual
telnet-tcp (23) [0 – 32767]: <Enter>
Stepping mode ended.
M11 (top)>> save
WARNING: 'dns domain-name' is null, indicating no
domain name is available.
WARNING:
secondary-address [0.0.0.0]' indicates no nameserver
is available.
Configuration data saved.
M11 (top)>> exit
M11> restart
REBOOT scheduled in 2 seconds
Goodbye.
The following changes were made in the above basic router example:
D
Ip-llc encapsulation was selected for ATM channel 1. This
encapsulation is used by your company's main office router.
Alternatively vc-mux encapsulation could be used. See Chapter 6
for more information on the payload encapsulations.
D
IP address was assigned to the Ethernet port of your M11.
D
IP and broadcast addresses were assigned to the ATM/ADSL
interface of your M11.
D
Address mapping was disabled because your PC and M11 belong
to your company network.
D
Default gateway was enabled and its IP address defines the IP
gateway interface.
D
IP address of the default gateway was given.
D
DHCP was disabled.
The warnings in the end of the above example indicate that the
addresses have not been specified. Messages given as Warnings are
not fatal. If an actual error message occurs, the configuration has not
been validated successfully and M11 does not save the configuration.

Step 4: Connect your M11 to the network

Connect the ADSL cable between a telephone socket and the LINE
connector of the M11. Then connect the Ethernet cross cable between
the Ethernet interface of your PC and the ETH connector of the M11.
4-14
'dns primary-address
E Copyright Nokia Networks Oy
[0.0.0.0]' and
C33833001SE_00
'dns