Chapter 4 Installing M11; Internet Access (Napt Router) - Nokia M11 T66220 User Manual

Chapter 4
Installing M11
This chapter presents step-by-step installation example procedures for
three different application examples of Nokia M11:
D

Internet access (NAPT router)

D
Remote work (basic router)
D
LAN interconnection (basic bridge)
These installation procedures are examples to guide you through some
of the typical use cases.
In the installation examples, we assume that you have a new M11 with
a factory default configuration. The complete default configuration is
presented in the end of this chapter. The default settings are, briefly:
D
Single ADSL/ATM channel (VPI = 0, VCI = 100)
D
PPP over ATM/AAL5 encapsulation
D
M11 retrieves IP address configuration from IP network using
PPP-IPCP negotiation
D
Network Address Port Translation activated
D
Private IP addresses in use in LAN
D
DHCP server for LAN interface activated
Before starting the installation, unpack the unit and check that it is
physically undamaged.
4.1 Internet access (NAPT router)
This application is based on the default configuration of the Nokia
M11. By default, Nokia M11 is an Internet access device that uses
C33833001SE_00
E Copyright Nokia Networks Oy
Installing M11
4-1