Static Route Settings - Nokia M11 T66220 User Manual

Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example

Static route settings

A static route identifies a manually configured pathway to a remote
network. Unlike dynamic routes, which are acquired and confirmed
periodically from other routers, static routes do not time out.
Consequently, static routes are useful when working with PPP, since
an intermittent PPP link may make maintenance of dynamic routes
problematic.
C33833001SE_00
Enable/disable RIP receive function on channels
using PPP over ATM encapsulation in bridged
mode
Specifies whether M11 should use Routing information
protocol (RIP) broadcasts to update its routing tables
with information received from other routers on the
other side of the specified ATM link using PPP over
ATM encapsulation in bridged mode.
set ip wan {vccx} rip-receive [off | v1 | v2 | v1-compat]
The first argument identifies the ATM channel (vccx,
x = 1 ... 8). If there is only one ATM channel using PPP
over ATM encapsulation in bridged mode, you can
leave the argument vccx out. Both RIP version 1 and
RIP version 2 functionalities can be simultaneously acti-
vated. v1-compat argument enables the receiving of
both RIPv1 and RIPv2 packets. RIP cannot be acti-
vated if address mapping is ON.
M11> set ip wan vcc2 rip-receive off
Enable/disable the management through channels
using PPP over ATM encapsulation
Enables/disables the management of M11 through the
specified ATM link using PPP over ATM encapsulation.
set ip wan {vccx} admin-disable [on|off]
The first argument identifies the ATM channel (vccx,
x = 1 ... 8). If there is only one ATM channel using PPP
over ATM encapsulation in bridged mode, you can
leave the argument vccx out. The second argument
disables/enables management through ATM channel
using PPP-vcmux encapsulation.
M11> set ip wan vcc2 admin-disable on
E Copyright Nokia Networks Oy
Management
5-69