Nokia M11 T66220 User Manual page 72

2. Enable/disable IP.
IP setting allows you to activate the IP layer function of the ATM
channel. Local address, net mask and broadcast address specify
the basic IP address parameters of the ATM channel interface (IP
over RFC1483). If you enter 0.0.0.0 in these fields, M11 will try to
get them from the network using either IPCP protocol (ATM
channel using PPP) or DHCP (ATM channel not using PPP).
Address mapping radio button activates/deactivates the Network
Address Port Translation (NAPT).
3. Configure Routing Information Protocol (RIP) settings.
Enable/disable dynamic routing for the active IP interface on the
ATM channel by selecting the corresponding radio buttons. If
RIP-send, is selected M11 sends RIP messages (version 1, 2 or
both) to the network. If RIP-receive is selected, M11 listens to RIP
messages from the network. RIP-send with V1-compat option
enables the sending of RIPv2 packets using broadcast.
RIP-receive with V1-compat option accepts both RIPv1 and
RIPv2 packets.
4. Add static routes to the routing table of the interface.
Enter destination address, net mask and gateway and click Add.
5. Save the configuration.
You must save the new configuration. Save command takes you to
the M11 home page.
6. Restart your M11.
You must restart your M11 by clicking Restart M11 for your
changes to take effect.
C33833001SE_00
E Copyright Nokia Networks Oy
Management
5-17