Nokia M11 User's Manual
Pinhole settings
Pinhole settings are used to configure static entries to NAPT table. The
pinhole function allows access to servers, such as Web-HTTP servers,
from outside your local LAN in cases where NAPT/address mapping
is enabled. The settings affect the whole system.
Note
If you have a Web server on LAN, make sure that it has a different port
number than M11's integral Web server. You can change the M11's
Web server port through the integral server settings.
Command
Description
Syntax
Arguments
Example
5-88
Configure pinhole
Configures pinhole.
set pinhole name [name] protocol-select [tcp | udp |
icmp | pptp] external-port-start [port_number] external-
port-end [port_number] internal-ip [ip_address] internal-
port [port_number]
The name argument defines the unique pinhole entry
name.
The protocol-select argument specifies the proto-
col.
The external-port-start specifies the start of the
external port range.
The external-port-end specifies the end of the ex-
ternal port range. Together the external port arguments
define the available range of allowed external ports.
The internal-ip argument specifies the IP address
of the server located in LAN and the internal-port
argument its port. Valid values for port_number are 0
– 65535.
m11> set pinhole name web-server proto-
col-select tcp external-port-start 80 ex-
ternal-port-end 80 internal-ip
192.168.1.180 internal-port 80
E Copyright Nokia Networks Oy
C33833001SE_00