Filling In Router Settings - Nokia M11 T66220 User Manual

Nokia M11 User's Manual

Filling in router settings

1. Enter the name of your M11 in the System Name field.
Each M11 is assigned a name as a part of its factory initialisation.
The default name is M11. A system name can be 1-64 characters
long and cannot contain any special characters. If you want to use a
space character in the system name, you must use quotes, for
example "Nokia M11". The name can be later used to access the
M11 through a telnet connection or a Web page from the Ethernet
interface.
2. Enter the IP address of your M11.
Local address is the IP address of your M11's Ethernet interface.
3. Enter the subnet mask.
Net mask is used to identify the network portion of an IP address.
The net mask specifies which bits of the 32-bit binary IP address
represent the network information. Most sites should use
255.255.255.0 for their net mask.
4. Enter the broadcast address.
The Broadcast address is used to send messages to all computers
on your network. Most sites should use xxx.yyy.zzz.255 as their
broadcast address, where xxx.yyy.zzz is the network portion of the
IP address.
5. Enable/disable management through the Ethernet port (Admin
Restrictions).
You can disable management through the Ethernet port by clicking
Admin-Disabled. You must have admin rights to set admin
restrictions.
Note
If you disable management through the Ethernet port and restart M11,
you can no longer manage M11 with your local telnet or Web browser.
5-8
E Copyright Nokia Networks Oy
C33833001SE_00