HP 4800G Series Configuration Manual page 660

4.4.4.4 1
# Display OSPFv3 routing table information on Switch D.
[SwitchD] display ospfv3 routing
E1 - Type 1 external route,
E2 - Type 2 external route,
OSPFv3 Router with ID (4.4.4.4) (Process 1)
------------------------------------------------------------------------
*Destination: 2001::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
*Destination: 2001:1::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
*Destination: 2001:2::/64
Type : I
NextHop : directly-connected
*Destination: 2001:3::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
3) Configure Area 2 as a stub area
# Configure Switch D
[SwitchD] ospfv3
[SwitchD-ospfv3-1] area 2
[SwitchD-ospfv3-1-area-0.0.0.2] stub
# Configure Switch C, and specify the cost of the default route sent to the stub area as 10.
[SwitchC] ospfv3
[SwitchC-ospfv3-1] area 2
[SwitchC-ospfv3-1-area-0.0.0.2] stub
[SwitchC-ospfv3-1-area-0.0.0.2] default-cost 10
# Display OSPFv3 routing table information on Switch D. You can find a default route is added, and its
cost is the cost of a direct route plus the configured cost.
[SwitchD] display ospfv3 routing
E1 - Type 1 external route,
E2 - Type 2 external route,
OSPFv3 Router with ID (4.4.4.4) (Process 1)
------------------------------------------------------------------------
*Destination: ::/0
Type : IA
NextHop : FE80::F40D:0:93D0:1
Full/DR 00:00:38
IA - Inter area route,
* - Seleted route
IA - Inter area route,
* - Seleted route
1-18
Vlan400 0
I - Intra area route
Cost : 2
Interface: Vlan400
Cost : 3
Interface: Vlan400
Cost : 1
Interface: Vlan400
Cost : 4
Interface: Vlan400
I - Intra area route
Cost : 11
Interface: Vlan400