Ethernet Port Configuration; Initially Configuring A Port - H3C S3600-28P-SI Operation Manual

Operation Manual – Port Basic Configuration
H3C S3600 Series Ethernet Switches-Release 1510
Note:
The access ports or hybrid ports must be added to an existing VLAN.

1.2 Ethernet Port Configuration

1.2.1 Initially Configuring a Port

Table 1-3 Initially configure a port
Enter system view
Enter Ethernet port view
Enable the Ethernet port
Set the description of the
Ethernet port
Set the duplex mode of
the Ethernet port
Set the speed of the
Ethernet port
Set
dependent
(MDI) attribute of the
Ethernet port
Allow jumbo frames that
are not larger than 9216
bytes to pass through the
Ethernet port
Operation
system-view
interface
interface-number
undo shutdown
description text
duplex { auto | full | half }
speed { 10 | 100 | 1000 |
auto }
the medium
interface mdi { across | auto |
normal }
jumboframe enable
Chapter 1 Port Basic Configuration
Command
interface-type
1-4
Remarks
—
—
Optional
By default, the port is
enabled.
Use the shutdown
command to disable the
port.
Optional
By default, no description
is defined for the port.
Optional
By default, the duplex
mode of the port is auto
(auto-negotiation).
Optional
By default, the speed of
the port is auto
(auto-negotiation).
Optional
Be default, the
attribute of the port is
auto.
Optional
By default, jumbo frames
that are not larger than
9216 bytes are allowed to
pass through the port.
MDI