Settings Related To Sheet Counters; Checking And Resetting The Sheet Counters - Fujitsu fi-7160 Operator's Manual

Chapter 9 Operational Settings

9.4 Settings Related to Sheet Counters

Checking and Resetting the Sheet Counters

■Checking the sheet counters
The status of each consumable part can be viewed to
determine when to replace or clean the consumables.
The color of the counter changes to prompt replacement or
cleaning. The color of each counter changes when:
The consumable counter turns light yellow when the page count
after replacing the consumable reaches 95% of the value specified
in "Replacement Cycle of Consumables [Life Counter Alarm
Setting]" (page 181), and turns yellow when it reaches 100%.
The cleaning counter turns yellow when the page count after
cleaning reaches 100% of the value configured in
Cleaning Cycle [Cleaning Cycle]" (page 181)
Operation Panel.
Ink counter turns yellow when the amount of remaining ink
reaches below 33% (only displayed when the imprinter is
installed).
1
Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163).
2
From the listing on the left, select [Device Setting].
"Scanner
in the Software
In this dialog box, you can check the following items:
Total Page Count
(ADF)
Total Page Count (FB)
(fi-7260/fi-7280)
After cleaning
Brake Roller
Pick Roller
Item Description
Approximate total number of sheets
scanned through the ADF
Approximate total number of sheets
scanned on the flatbed (fi-7260/fi-7280)
Approximate total number of sheets
scanned after cleaning
Number of sheets scanned after
replacing the brake roller
Number of sheets scanned after
replacing the pick roller
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
178