Scan Settings; Configuring The; Operator Panel; Various Ways To - Fujitsu fi-7160 Operator's Manual

Chapter 6 Daily Care
3
Clean the following locations with a cloth moistened with
Cleaner F1 or a sheet of Cleaning Wipe.
Glass ( 2)
×
Ultrasonic sensor ( 2)
×
Brake roller ( 2)
×
Feed roller ( 2)
×
Eject roller
( 2)
×
Document
sensor
( 8)
×
Pick roller
( 2)
×
Plastic idler
roller ( 2)
×
Rubber idler
roller ( 2)
×
Brake roller ( 2)
×
Remove the roller from the scanner.
For details about removing the brake roller, refer to
Brake Roller" (page 121).
Gently wipe off any dirt or dust along the grooves, taking care not to
damage the roller surface.
Pick roller ( 2)
×
Gently wipe off any dirt or dust along the grooves as you rotate the roller
manually, taking care not to damage the roller surface. Make sure that it
is wiped properly because black residue on the roller will affect the
feeding performance.
Plastic idler roller ( 2)
×
Gently wipe off any dirt or dust on the surface of the rollers. Make sure
that it is wiped properly because black residue on the roller will affect the
feeding performance.
Rubber idler roller ( 2)
×
Gently wipe off any dirt or dust on the surface of the rollers. Make sure
that it is wiped properly because black residue on the roller will affect the
feeding performance. When wiping, be careful not to damage the
sponge that is attached to the middle of the rubber idler roller.
Glass ( 2)
×
Gently wipe the dirt and dust off the surface of the glass sections.
ATTENTION
Vertical streaks may appear on the scanned image when the glass is
dirty.
TOP
Contents
Index

"7.2 Replacing the

Introduction
Scanner
Overview
How to Load
Documents

Configuring the

Scan Settings

How to Use the

Operator Panel

Various Ways to

Scan

Daily Care

Replacing the

Consumables

Troubleshooting
Operational
Settings
Appendix
Glossary
114