Fujitsu fi-7160 Operator's Manual page 196

Chapter 9 Operational Settings
3
Select a detection method.
Method
None Does not detect multifeed.
Check Detects multifeed by the overlapping of
Overlapping documents.
(Ultrasonic) When this is selected, you can also specify the
two following options:
Specify the detection range by the length from
the top of the document.Proceed to
"Specifying the Area to Detect Multifeed
[Document check area specification for
Multifeed Detection]" (page 197)
details.
Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.Proceed to
"Ignoring Multifeed for a Set Pattern" (page
103) for more details.
Check Length Detects multifeed by the difference in length of the
documents.
Note that
accurately when scanning a mixed batch of
different sizes.
Description
for more
multifeeds cannot be detected
Method Description
Check Detects multifeed by the combination of [Check
Overlapping Overlapping (Ultrasonic)] and [Check Length].
and Length Note that multifeeds
accurately when scanning a mixed batch of
different sizes.
When this is selected, you can also specify the
two following options:
Specify the detection range by the length from
the top of the document.Proceed to
"Specifying the Area to Detect Multifeed
[Document check area specification for
Multifeed Detection]" (page 197)
details.
Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.Proceed to
"Ignoring Multifeed for a Set Pattern" (page
103) for more details.
Length Select a length difference from 10/15/20 mm. Any
length under the specified value will not be
detected as multifeed.
ATTENTION
To scan documents with different lengths, specify [Check
Overlapping (Ultrasonic)].
When an attachment such as a sticky note, receipt, or photo is
attached on the document, the overlapping part of the
document may be falsely detected as multifeed if [Check
Overlapping (Ultrasonic)] is specified. In that case, specify
[Check Length].
Note however that [Check Overlapping (Ultrasonic)] can still be
used by restricting the detection range.
Multifeed cannot be detected when using the Carrier Sheet.
HINT
This setting can also be configured in the scanner driver.
Note that priority is given to the scanner driver setting.
Contents
Index
Introduction
cannot be detected
Scanner
Overview
How to Load
Documents
Configuring the
for more
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
196