Settings Related To Scanner Maintenance; Detecting Vertical Streaks [Vertical Streak Detection] - Fujitsu fi-7160 Operator's Manual

Chapter 9 Operational Settings

9.9 Settings Related to Scanner Maintenance

Detecting Vertical Streaks [Vertical Streak
Detection]
Select whether to enable or disable vertical streak detection.
After enabling this setting,
a vertical streak may occur in the images that are scanned
through the ADF.
[Clean glass!] also flashes on the second line in the [Ready]
screen.
Check the information, and then clean the glass.
For details about checking the information, refer to
the information" (page 71).
For details about cleaning, refer to
(page 108).
flashes on the LCD when
"Checking
"Chapter 6 Daily Care"
1
Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163).
2
From the listing on the left, select [Device Setting 2]
[Vertical Streak Detection].
3
Select whether to enable or disable [Vertical Streak
Detection].
When you select [Enable], the scanner detects vertical streaks (dirt
on the glass) during scanning with the ADF.
HINT
This setting can also be configured in the operator panel.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
204