Fujitsu fi-7160 Operator's Manual page 179

Chapter 9 Operational Settings
Item
Remaining Ink Amount of ink remaining in the print
cartridge of the imprinter
(Only displayed when imprinter is
installed)
ATTENTION
If the scanner was turned off by unplugging the power cable, or
[Disable power switch] is selected, the number of scanned sheets
may not be counted in [Total Page Count].
For details about disabling the power switch, refer to
Turning the Scanner ON/OFF [Power SW Control]" (page
■Resetting the sheet counters
Description
When you have replaced or cleaned a consumable part, reset the
corresponding counter by using the following procedure.
1
"Method of
203).
2
3
If you have replaced a consumable, click the [Clear]
button of the consumable that you replaced. If you
performed cleaning, click the [Clear] button of [After
cleaning].
The counter is reset to 0.
For ink counter, the value will be set to 100.
Click the [OK] button in the Software Operation Panel.
A confirmation message appears.
Click the [OK] button.
The settings are saved.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
179