Fujitsu fi-7160 Operator's Manual page 132

Chapter 8 Troubleshooting
Error Error messages
code
J2:55 Multifeed detected
(Overlap)
Press the Scan button to
eject the document.
After ejecting the
document, multifeed
detection for the next
document can be
enabled/disabled from
the Menu button.
Multifeed detected
(Overlap)
Press the Scan button to
eject the document.
Press the Menu button to
memorize the multifeed
pattern.
Multifeed detected
(Overlap)
Press the Scan button to
eject the document.
J2:56 Multifeed detected
(Length)
Press the Scan button to
eject the document.
Resolution
1 Press the [Scan/Enter] button on
the operator panel to eject the
documents.
2 Press the [Menu] button on the
operator panel, select whether or
not to detect multifeed, and then
press the [Scan/Enter] button or
perform a scan from the
computer.
1 Press the [Scan/Enter] button on
the operator panel to eject the
documents.
2 Press the [Menu] button on the
operator panel, select whether or
not to memorize the pattern, and
then press the [Scan/Enter]
button or perform a scan from the
computer.
1 Press the [Scan/Enter] button on
the operator panel to eject the
documents.
2 Press the [Scan/Enter] button on
the operator panel or perform a
scan from the computer.
1 Press the [Scan/Enter] button on
the operator panel to eject the
documents.
2 Press the [Scan/Enter] button on
the operator panel or perform a
scan from the computer.
Error Error messages
code
J8:01 Sensor(s) dirty
Clean the Pick Sensor.
J8:04 Sensor(s) dirty
Clean the READ-TOP
Sensor.
■Transport lock, cover open, and print errors
Error codes beginning with the letter "U" are displayed.
Error Error messages
code
U0:10 Transport lock Unlock the transport lock switch.
error For details, refer to "Installing the
Unlock the Scanner" in Getting Started.
transport lock
switch.
(fi-7260/fi-7280)
U4:40 ADF open Close the ADF and reload the
(*1) documents.
U5:4A Imprinter Cover Close the print section of the imprinter,
(*2) Open and load the document again.
(only when
imprinter is
installed)
U6:B4 Print cartridge not This error is related to the imprinter.
installed For details, refer to the fi-718PR
Check if the Print Imprinter Operator's Guide.
Cartridge is
mounted
correctly.
(only when
imprinter is
installed)
Resolution
Open the ADF and clean the eight
document sensors.
For details, refer to "Chapter 6
Daily Care" (page 108).
Resolution
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
132