Chapter 4 How to Use the Operator Panel
■Checking the information
1 [Power] button
2 [Menu] button
3 [ ]/[ ] button
[Scan/Enter] button
4 [ ]/[ ] button
1
Press the [Power] button on the operator panel.
The [Ready] screen is displayed on the LCD.
2
Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
3
Press the [ ] or [ ] button and select [Information], then
press the [Scan/Enter] button to confirm.
The [Information] screen is displayed on the LCD.
ATTENTION
[Information] can be selected only when there is a message for
replacing consumables/cleaning/glass cleaning/regular
maintenance.
4
Press the [ ] or [ ] button to check the contents of the
information.
You can check the messages for replacing consumables/cleaning/
glass cleaning/regular maintenance.
When the message prompts replacing consumables/cleaning, the
corresponding counter that requires consumable replacement/
cleaning is highlighted. The counter will appear highlighted when:
The page count after replacing the consumable reaches 95% of the
value configured in
"Replacement Cycle of Consumables [Life
Counter Alarm Setting]" (page 181)
Panel. (For brake roller/pick roller counters)
The page count after cleaning reaches 100% of the value
configured in
"Scanner Cleaning Cycle [Cleaning Cycle]" (page
181)
in the Software Operation Panel. (Cleaning counter)
The amount of remaining ink reaches below 33%. This is only
displayed when the imprinter is installed. (For ink counter)
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
in the Software Operation
Replacing the
Consumables
Troubleshooting
Operational
Settings
TOP
Contents
Index
Introduction
Appendix
Glossary
71