Fujitsu fi-7160 Operator's Manual page 173

Chapter 9 Operational Settings
Item
Multifeed
(page 195)
Page Edge Filler (ADF)
Page Edge Filler (FB)(For fi-
7260/fi-7280)
(page 184)
Dropout color
(page 186)
Pre-Pick
(page 187)
Description
Specify a method for multifeed detection. Detect
multifeeds by monitoring the overlap, document
length, or the combination of both.
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
Specify a width for the margin around the edge
of the scanned image to fill in white or black,
according to the background color.
This setting can also be configured in the
scanner driver. In that case, Page Edge Filler of
the scanner driver is used on the output image.
Select a color to be removed from the scanned
image (only available in black & white or
grayscale mode).
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
Select [Yes] to prioritize the processing speed
and [No] for otherwise.
This setting can also be configured in the
scanner driver or the operator panel. Note that
priority is given to the scanner driver setting.
Parameter/Value
None / Check Overlapping (Ultrasonic) /
Check Length / Check Overlapping and
Length
Length (When [Check Length] is specified;
select from 10/15/20 mm)
ADF:
Top / Left / Right: 0 to 15 mm
Bottom: -7 to 7 mm (in increments of 1)
FB (For fi-7260/fi-7280):
Top / Bottom / Left / Right: 0 to 15 mm
(A: image, B: filled area, A+B: output)
Red / Green / Blue / None
Yes / No
TOP
Contents
Factory Default
Index
None
Introduction
Length: 10 mm
Scanner
Overview
How to Load
Top/Bottom/Left/
Right: 0 mm
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Green
Daily Care
Replacing the
Consumables
Yes
Troubleshooting
Operational
Settings
Appendix
Glossary
173