Fujitsu fi-7160 Operator's Manual page 124

Chapter 7 Replacing the Consumables
3 Lift up the bushing in direction
2
shaft in direction to pull out the leading end from the slot, then
3
lift the shaft in direction
2
ATTENTION
Be careful not to touch the gear near the bushing on the shaft as it
contains grease.
1
(about 5 mm), and slide the
to remove it.
3
Bushing
1
Shaft
5
Remove the two pick rollers from the shaft one at a time.
1 Pull out the pick roller from the shaft as you lift the retaining clip.
2 Pull out the other pick roller from the shaft as you lift the retaining
clip.
TOP
Contents
Index
Introduction
Scanner
Retaining clip
Overview
Shaft
How to Load
Pick roller
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Retaining clip
Various Ways to
Shaft
Scan
Pick roller
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
124