Chapter 8 Troubleshooting
Paper protection is set off frequently.
Do the documents meet the requirements described in
"Precautions" in
"Conditions" (page
Yes
Is there any foreign matter inside the ADF?
No
Are the consumables (*1) installed correctly?
Yes
Are the consumables (*1) clean?
Yes
Are the consumables (*1) worn out?
No
Is the high altitude mode enabled in the Software
Operation Panel?
No
Use documents that meet the requirements.
45)?
For details, refer to
No
Clean the ADF. If there is any foreign matter in the ADF, remove it.
For details, refer to
Yes
Install the consumables (*1) correctly.
For details, refer to
No
Clean the consumables (*1).
For details, refer to
No
Check the consumable counters and replace them if necessary.
For details, refer to
Yes
Disable the high altitude mode in the Software Operation Panel when using the
scanner in places lower than 2,000 m.
Yes
For details, refer to
"2.3 Documents for Scanning (ADF)" (page
"Chapter 6 Daily Care" (page
108).
"Chapter 7 Replacing the Consumables" (page
"Chapter 6 Daily Care" (page
108).
"Chapter 7 Replacing the Consumables" (page
"Scanning at High Altitude [High Altitude Mode]" (page
TOP
Contents
Index
Introduction
45).
Scanner
Overview
How to Load
Documents
119).
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
119).
Scan
Daily Care
194).
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
150