Chapter 2 How to Load Documents
Fig. 1
35
Reference point
Front side
Feed
direction
ATTENTION
The above condition applies when the document is set to the center
of the pick roller width.
When you use detection by overlapping, scanning thick documents
such as plastic cards will be falsely detected as multifeed.
In that case, to scan documents successfully, use the multifeed
window display function of the scanner driver, use the Intelligent
Multifeed function, or disable the multifeed detection.
Top
Bottom
Center
( Unit: mm)
HINT
Accuracy of multifeed detection may drop with some documents.
Multifeed cannot be detected for the top 30 mm of a document.
For the shaded area in Fig. 1, you can also specify a length not to
detect multifeeds in the Software Operation Panel.
For details, refer to
"9.6 Settings Related to Multifeed Detection"
(page
195).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
50