Fujitsu fi-7160 Operator's Manual page 171

Chapter 9 Operational Settings
Item
Count Check the counters to determine when to replace the
(page 178) consumables and to perform cleaning.
Also use it to reset the counter when you have replaced the
consumables or performed cleaning.
Power saving Specify the waiting time before entering power saving mode.
(page 202) This setting can also be configured in the operator panel.
Power off after a certain period of time: Select to set the
scanner to turn the power off automatically if the scanner is left
on for a certain period of time without being used.
Specify the timeout period for the scanner to be automatically
turned off.
This setting can also be configured in the operator panel.
Offset Setting Adjust the position to start the scan on the selected scanning
(page 183) side(s).
Vertical Adjust the magnification level in feed direction for the selected
magnification scanning method.
Adjustment
(page 183)
*1: Displayed when using the fi-7260 or fi-7280.
*2: Displayed when the imprinter is installed.
Description Parameter/Value
Total Page Count(ADF) / Total Page Count(FB) (*1)/
After cleaning/Brake Roller/Pick Roller
Remaining Ink (when the imprinter is installed)
Range: 5 to 235 min. (in increments of 5)
[Power off after a certain period of time] check box
1 Hour/2 Hours/4 Hours/8 Hours
(When the [Power off after a certain period of time]
check box is selected)
Unit: Flat bed (*1) / ADF(front) / ADF(back)
Main/Sub: -2 to 2 mm
(in increments of 0.5)
Unit: Flat bed (*1) / ADF
Range: -3.1 to 3.1% (in increments of 0.1)
TOP
Contents
Factory Default
Index
0
Introduction
Scanner
(*2)
Overview
15 min.
How to Load
Selected
Documents
4 Hours
Configuring the
Scan Settings
How to Use the
Main/Sub: 0 mm
Operator Panel
Various Ways to
0%
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
171